- AUTHENTICATION SERVERS ARE DOWN 1.7.2 HOW TO
- AUTHENTICATION SERVERS ARE DOWN 1.7.2 PASSWORD
- AUTHENTICATION SERVERS ARE DOWN 1.7.2 MAC
Configure the following parameters for Called Station ID: For more information, see RADIUS Service-Type Attribute.Įnable or disable RADIUS over TLS for this server.Įnter the trusted CA name to be used to verify this server.Įnter the name of the trusted Radsec server certificate.Įnter the name of the Radsec client certificate that the controller should use for Radsec requests.Īllows user to send different values for Called Station ID. Send the service-type as FRAMED-USER instead of LOGIN-USER.
AUTHENTICATION SERVERS ARE DOWN 1.7.2 MAC
Oui-nic: Send MAC address as XXXXXX-XXXXXX Send MAC address with the following delimiters in the authentication and accounting requests of this server: Ĭolon: Send MAC address as XX:XX:XX:XX:XX:XXĭash: Send MAC address as XX-XX-XX-XX-XX-XX Send MAC address with lowercase in the authentication and accounting requests to this server. If you do not associate the Source Interface with a configured server (leave the field blank), the IP address of the global Source Interface is used. If you associate a Source Interface (by entering a VLAN number) with a configured server, then the source IP address of the packet is that interface’s IP address. The NAS IPv6 address to be sent in RADIUS packets.Īllows you to use source IP addresses to differentiate RADIUS requests.Īssociates a VLAN interface with the RADIUS server to allow the server-specific source interface to override the global configuration. NOTE: If you define a local NAS IP using the Configuration > Security > Authentication > Servers page and also define a global NAS IP using the Configuration > Security > Authentication > Advanced page, the global NAS IP address takes precedence. The NAS IP address to be sent in RADIUS packets from that server. Network Access Server (NAS) identifier to use in RADIUS packets. Maximum time, in seconds, that the controller waits before timing out the request and resending it. Maximum number of retries sent to the server by the controller before the server is marked as down.
AUTHENTICATION SERVERS ARE DOWN 1.7.2 PASSWORD
The maximum length is 128 characters.Īllows the controller to use configurable username and password instead of a support password. Shared secret between the controller and the authentication server. The maximum supported FQDN length is 63 characters. IP address or fully qualified domain name (FQDN) of the authentication server. Table 1: RADIUS Server Configuration Parameters (host)(config) #aaa authentication-server radius The configuration does not take effect until you perform this step. Select the Mode checkbox to activate the authentication server. Enter the parameters as described in Table 1. Select the name to configure server parameters. To configure a RADIUS server, enter the name for the server and click Add. Select Radius Server to display the Radius Server List. Navigate to the Configuration > Security > Authentication > Servers page. This section includes the following information: Ĭonfiguring Username and Password for CPPM Authenticationįollow the procedures below to configure a RADIUS server using the WebUI or CLI.
AUTHENTICATION SERVERS ARE DOWN 1.7.2 HOW TO
This section describes how to configure RADIUS, LDAP, TACACS+ and Windows external authentication servers and the internal database on the controller. Configuring Authentication Servers Configuring Authentication Servers